Average Rating: 4
$745.65 + 3 Business Day Shipping $62.89
Specs
| Item | Sprinkler Pump |
|---|---|
| Type | Self-Priming |
| HP | 2 |
| Phase | 1 |
| Voltage | 115/208-230 |
| Amps | 24.66/12.95-12.33 |
| Hz | 60 |
| Inlet (In.) | 1-1/2 |
| Outlet (In.) | 1-1/2 |
| Suction Lift (Ft.) | 25 |
| Length (In.) | 18-3/4 |
| Width (In.) | 8 |
| Height (In.) | 10-11/16 |
| GPM @ 10 PSI | 89 |
| GPM @ 15 PSI | 82 |
| GPM @ 20 PSI | 75 |
| GPM @ 25 PSI | 66 |
| GPM @ 30 PSI | 57 |
| GPM @ 35 PSI | 47 |
| GPM @ 40 PSI | 37 |
| GPM @ 45 PSI | 24 |
| GPM @ 50 PSI | 10 |
| Shut-Off (Ft.) | 124 |
| Max. Pressure (PSI) | 54 |
| Best Efficiency GPM @ Head (Ft.) | 50 @ 85 |
| Best Efficiency Range GPM @ Head (Ft.) | 66-10GPM @ 57-104 FT |
| Stages | 1 |
| Motor Enclosure | TEFC |
| Motor Type | Capacitor-Start, Capacitor-Run |
| NEMA/IEC Frame | 56J |
| RPM | 3450 |
| Service Factor | 1.2 |
| Wetted Materials | Cast Iron, Stainless Steel, Buna-N, Carbon, Ceramic |
| Housing Material | Cast Iron |
| Impeller Material | Stainless Steel |
| Volute Material | Cast Iron |
| Seal Type | Buna N O-Ring Casing, Mechanical |
| Seal Material | Buna-N, Carbon, Ceramic, Stainless Steel |
| Seal Application | Nonflammable Liquids Compatible with Pump Components |
| Shaft Material | Stainless Steel |
| Screw Material | Plated Steel |
| GPM of Water @ 2 Ft. of Head | 96 |
| Thermal Protection | Automatic Reset |
| Bearing Type | Double Shielded Pre Lubricated Ball |
| Max. Specific Gravity | 1 |
| Max. Case Pressure (PSI) | 150 |
| Max. Fluid Viscosity | 31 SSU |
| Inlet Pressure (PSI) | 96 |
| Impeller Type | Closed |
| Duty | Continuous |
| Port Rotation | 90 Degrees Increments |
| Drain Plug | Yes |
| Agency Compliance | Motor Only CSA |
| Manufacturers Warranty Length | 1 Year |
| Features | Removable and Replaceable Volute/Diffusers, Front Drain Plug |
| For Use With | Nonflammable Liquids Compatible with Pump Component Materials |
| Application | Lawn Sprinking, Spraying Irrigation, Draining and General Dewatering Application, Etc. |
| Includes | Manual |
| UNSPSC | 40151503 |
| Weight | 86.750000 |
| SKUs | 5RWG9 |
Description
Sprinkler Pump, Self-Priming, Housing Material Cast Iron, Inlet 1-1/2 In, Outlet 1-1/2 In, 2 HP, 1 Phase, Voltage 115/208-230, Amps 24.66/12.95-12.33, 60 Hz, Suction Lift 25 Ft., Shut-Off 124 Ft., Max. Pressure 54 PSI, Stages 1, Motor Enclosure TEFC, Motor Type Capacitor-Start, Capacitor-Run, 3450 RPM, Application Lawn Sprinking, Spraying Irrigation, Draining and General Dewatering Application, Etc., Includes Manual
Self-Priming Lawn Sprinkler/Booster Pumps
- Pumps hold prime for efficient water transfer.
- Cast-iron housings
- Dayton
- Feature an easy clean-out design with a front drain plug and removable, replaceable cast-iron volute/diffusers and adapters. 1-phase pumps have built-in thermal overload protection.
- Max. fluid temp.: 180 F Max. casing pressure: 150 psi
Customer Reviews
Pump Delivery Service
Tuesday, May 08, 2012Pump received damaged by delivery service. The 8/32 screws on back of motor destroyed and needed to be replaced. The housing for wires was broken off and had to be reattached. The nuts and bolts at holding motor to wood during delivery, broken. Motor support bracket a little small for size and weight of motor. Replaced with larger mounting support bracket. After spending a couple of hours correcting defects, I installed and motor operation is according to specification.
HP
Better, stronger support base bracket, and a better mounting of electrical wire housing
