Solenoid Valve, 2 Way, NC, 3/4 In, Brass1A578 49867
Average Rating: n/a
|Number of Ways||2|
|Cv Flow Factor||5.50|
|Pipe Size (In.)||3/4|
|Orifice Dia. (In.)||3/4|
|PSI Differential Min.||5|
|Max. PSI Differential Air/Water||125|
|Safe Working Water PSI||300|
|Min. Flow Rate (GPM)||12.3|
|Coefficient of Volume||5.50|
|Max. Fluid Temp. (F)||180|
|Coil Insulation Class||F|
|Coil Enclosure||NEMA 1X|
|Gasket Material||Buna N|
|Construction Reference No.||2|
|Center Line Pipe Center Size (In.)||11/16|
|Agency Compliance||CSA, NFPA, UL|
- WARNING: Not for use in explosive atmospheres. Note: Maximum suggested cycling rate is 10 times per min.
- California Proposition 65 Warning: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm.
- To prevent backflow, add a check valve to the system (sold separately on page 4414). Valves that have OPD minimums beginning with 0 (e.g., 0 to 300 psi) are direct-acting and will open and close when line pressures are within minimum and maximum psi ranges. Valves that have OPD minimums starting at 2 or 5 (e.g., 5 to 150 psi) are designated pilot-operated and will open and close only if pressure differential between the inlet and outlet is within OPD ranges. Normally closed valves will open when energized. Normally open valves will close when energized.
- Standards: UL; CSA; Fluid Control Institute, Inc.; National Fluid Power Association (NFPA).
- Mount in any position