Taper Length Drill, Coolant Fed, 9.5mm
Average Rating: 1
|Item||Taper Length Drill|
|Point Type||Self-Centering Point|
|Drill Point (Deg.)||140|
|Flute Length (mm)||95|
|Overall Length (mm)||139|
|Shank Dia. (mm)||10|
|Application||High-Penetration Rate For Alloy And Tool Steel, Cast Iron, General Steel, Heat-Treated Steel, Nickel Alloys, Stainless Steel And Titanium|
- California Proposition 65 Warning: This product contains a chemical known to the State of California to cause cancer.
- High penetration rate drills with self-centering design run 3 to 5 times faster than conventional drills, and create short chips. For drilling steel, stainless steel, cast iron, and nickel alloys. FIREX coating provides 90+ Rockwell hardness and can run 300 F hotter than standard TiN coating.
- Self-centering point FIREX coated List# 5512
Average Product Rating: 1based on 1 reviews
Not Very HappyTuesday, October 25, 2011
I needed this drill for a very important and rush job, i had this drill shipped UPS Red so that i could get it overnight, I did get the drill the next day, but when I tried to use it, we found that the drill was cutting oversized, the drill was a Dia. .375" but it was drilling a dia. .379", my tolerance for the job was .375 plus or mins .003. My machinest determined the drill bit was not cut right and that is the reason the drill was cutting oversized. My options at that point was to return the drill and get another and hope it will do the job or just get a refund, or try to sharpen the drill to see if we could use it. We decided to resharpen the drill and see if we could use it. Resharping the drill did not work so we had to order another drill from another source; we lost 2 days and the job ended up shipping late. I did not bother to return the drill because we tried to reshapen it and I did not think a return would be accepted.
The fast shipping
A non-defective drill bit.